As of yesterday night, my computer decided that it doesn't want to work properly because most of my RAM isn't being detected and my Windows 7 is showing the BSOD everytime I start it up. This turn of events happened when I changed the thermal paste on my CPU. With the RAM, I have 6x 4GB 1333 MHz Hynix ECC RAM installed on my computer. I've never had a problem with this until now. Fortunately, I have a 2.5" hard drive enclosure that connects to my laptop that performs a LOT LESS than my main computer. Using a backup service called Acronis True Image, it says that backing up all ~430 GB of my data will take 2d 9hrs to complete. Expect a delay in uploading any videos in the future.
UPDATE 2/28/20: I have reinstalled everything that I've backed up from Acronis and also replaced the motherboard. It turns out that I've damaged the CPU socket which didn't allow the computer to read every stick of RAM installed on my computer. If I were to boot up the computer using the old mobo, it would give me an error stating there is a "Memory failure in DIMM 1." It also did the same in a couple other RAM slots except for two of them. Those two somehow worked which gave my 8GB of RAM that was readable on the computer and the rest was "Hardware Reserved." After installing the new mobo, I have NOT run into any new problems and all of my RAM is detected and usable! It only cost me $35 do replace it.
UPDATE 2/28/20: I have reinstalled everything that I've backed up from Acronis and also replaced the motherboard. It turns out that I've damaged the CPU socket which didn't allow the computer to read every stick of RAM installed on my computer. If I were to boot up the computer using the old mobo, it would give me an error stating there is a "Memory failure in DIMM 1." It also did the same in a couple other RAM slots except for two of them. Those two somehow worked which gave my 8GB of RAM that was readable on the computer and the rest was "Hardware Reserved." After installing the new mobo, I have NOT run into any new problems and all of my RAM is detected and usable! It only cost me $35 do replace it.